Service Manual
Page 43 of 50

*NOTE* This service manual is for a NON EN10 modified engine. Whilst most of the information is relevent, there are some critical differences.
For more information on EN10 modified engines, please contact
Mick Broom at Broom Development Engineering on +44 (0)1327 353023

< Previous Page | Page 43 | Next Page >

Remove the output shaft as a complete assembly.
Lift off the idler gear assembly along with the needle roller bearing and two thrust washers; pull out the rear (layshaft) selector spindle.
Lift out the front (mainshaft) selector spindle from its location in the crankcase, and slide the two rear selector forks out of engagement with the selector drum.
The selector drum may then be lifted out, noting that a thrust washer is fitted between the end of the drum and the timing side crankcase.

< Previous Page | Page 43 | Next Page >

Index