Service Manual
Page 42 of 50

*NOTE* This service manual is for a NON EN10 modified engine. Whilst most of the information is relevent, there are some critical differences.
For more information on EN10 modified engines, please contact
Mick Broom at Broom Development Engineering on +44 (0)1327 353023

< Previous Page | Page 42 | Next Page >

When the drive side case is lifted off, check the position of the four large shim-washers on the gearbox shafts, as these may remain located within the drive side case.
Once the cases are separated the crankshaft may be removed by lifting it from the timing side main bearing.
If an engine overhaul is being undertaken, remove also the oil pick-up assembly (4mm Allen key).
Lift out the gear spray tube from behind the rear cylinder.

< Previous Page | Page 42 | Next Page >

Index